Datasheet

20 ns/DIV
OUTPUT
INPUT
V
S
= ±5V, A
V
= +6, R
F
= 1k
R
G
= 200:R
L
= OPEN
2 V/DIV
0
50 100 150
I
OUT
(mA)
0.1
1
10
V
OUT
FROM V
-
(V)
200 250
V
S
= ±5V
25°C
-20mV
-500mV
0
50 100
I
OUT
(mA)
0.1
1
V
OUT
FROM V
+
(V)
150 200
10
V
S
= ±5V
25°C
20mV
500mV
LMH6657, LMH6658
www.ti.com SNOSA35F –AUGUST 2002–REVISED MARCH 2013
Figure 53. V
OUT
vs. I
SOURCE
(for Various Overdrive)
Figure 54. V
OUT
vs. I
SINK
(for Various Overdrive)
The LMH6657/6658 output stage is designed to swing within approximately one diode drop of each supply
voltage by utilizing specially designed high speed output clamps. This allows adequate output voltage swing
even with 5V supplies and yet avoids some of the issues associated with rail-to-rail output operational amplifiers.
Some of these issues are:
• Supply current increases when output reaches saturation at or near the supply rails
• Prolonged recovery when output approaches the rails
The LMH6657/6658 output is exceedingly well-behaved when it comes to recovering from an overload condition.
As can be seen from Figure 55 below, the LMH6657/6658 will typically recover from an output overload condition
in about 18ns, regardless of the duration of the overload.
Figure 55.
Copyright © 2002–2013, Texas Instruments Incorporated Submit Documentation Feedback 17
Product Folder Links: LMH6657 LMH6658