Datasheet

Table Of Contents

= K ln (N)

k T

= I

LM86

www.ti.com

SNIS114E –DECEMBER 2001–REVISED MARCH 2013

(3)

In the above equation, η and I

are dependant upon the process that was used in the fabrication of the particular

diode. By forcing two currents with a very controlled ration (N) and measuring the resulting voltage difference, it

is possible to eliminate the I

term. Solving for the forward voltage difference yields the relationship:

(4)

The nonideality factor, η, is the only other parameter not accounted for and depends on the diode that is used for

measurement. Since ΔV

is proportional to both η and T, the variations in η cannot be distinguished from

variations in temperature. Since the nonideality factor is not controlled by the temperature sensor, it will directly

add to the inaccuracy of the sensor. For the Pentium III Intel specifies a ±1% variation in η from part to part. As

an example, assume a temperature sensor has an accuracy specification of ±1°C at room temperature of 25 °C

and the process used to manufacture the diode has a nonideality variation of ±1%. The resulting accuracy of the

temperature sensor at room temperature will be:

ACC

= ± 1°C + (±1% of 298 °K) = ±4 °C (5)

The additional inaccuracy in the temperature measurement caused by η, can be eliminated if each temperature

sensor is calibrated with the remote diode that it will be paired with. The following table shows the variations in

nonideality for a variety of processors.

Processor Family η, nonideality

min typ max

Pentium II 1 1.0065 1.0173

Pentium III CPUID 67h 1 1.0065 1.0125

Pentium III CPUID 68h/PGA370Socket/Celeron 1.0057 1.008 1.0125

Pentium 4, 423 pin 0.9933 1.0045 1.0368

Pentium 4, 478 pin 0.9933 1.0045 1.0368

MMBT3904 1.003

AMD Athlon MP model 6 1.002 1.008 1.016

Compensating for Diode Nonideality

In order to compensate for the errors introduced by nonideality, the temperature sensor is calibrated for a

particular processor. National Semiconductor temperature sensors are always calibrated to the typical nonideality

of a given processor type. The LM86 is calibrated for the nonideality of a mobile Pentium III processor, 1.008.

When a temperature sensor calibrated for a particular processor type is used with a different processor type or a

given processor type has a nonideality that strays from the typical, errors are introduced. Figure 16 shows the

minimum and maximum errors introduced to a temperature sensor calibrated specifically to the typical value of

the processor type it is connected to. The errors in this figure are attributed only to the variation in nonideality

from the typical value. In Figure 17 is a plot of the errors that result from using a temperature sensor calibrated

for a Pentium II, the LM84, with a typical Pentium 4 or AMD Athlon MP Model 6.

Product Folder Links: LM86