Datasheet

LM8272
SNOS515D –OCTOBER 2000–REVISED MARCH 2013 www.ti.com
Figure 40. Steady State Output Sinking Characteristics with Load Lines
OUTPUT SHORT CIRCUIT CURRENT AND DISSIPATION ISSUES:
The LM8272 output stage is designed for maximum output current capability. Even though momentary output
shorts to ground and either supply can be tolerated at all operating voltages, longer lasting short conditions can
cause the junction temperature to rise beyond the absolute maximum rating of the device, especially at higher
supply voltage conditions. Below supply voltage of 6V, output short circuit condition can be tolerated indefinitely.
With the Op Amp tied to a load, the device power dissipation consists of the quiescent power due to the supply
current flow into the device, in addition to power dissipation due to the load current. The load portion of the
power itself could include an average value (due to a DC load current) and an AC component. DC load current
would flow if there is an output voltage offset, or the output AC average current is non-zero, or if the Op Amp
operates in a single supply application where the output is maintained somewhere in the range of linear
operation. Therefore:
P
total
= P
Q
+ P
DC
+ P
AC
P
Q
= I
S
· V
S
Op Amp Quiescent Power Dissipation
P
DC
= I
O
· (V
r
- V
o
) DC Load Power
P
AC
= See Table 1 below AC Load Power
where:
• I
S
: Supply Current
• V
S
: Total Supply Voltage (V
+
- V
−
)
• V
O
: Average Output Voltage
• V
r
: V
+
for sourcing and V
−
for sinking current
Table 1 below shows the maximum AC component of the load power dissipated by the Op Amp for standard
Sinusoidal, Triangular, and Square Waveforms:
Table 1. Normalized AC Power Dissipated in the Output Stage for Standard Waveforms
P
AC
(W.Ω/V
2
)
Sinusoidal Triangular Square
50.7 × 10
−3
46.9 × 10
−3
62.5 × 10
−3
14 Submit Documentation Feedback Copyright © 2000–2013, Texas Instruments Incorporated
Product Folder Links: LM8272