Datasheet

LM675
SNOSBP3E –MAY 1999–REVISED MARCH 2013 www.ti.com
These devices have limited built-in ESD protection. The leads should be shorted together or the device placed in conductive foam
during storage or handling to prevent electrostatic damage to the MOS gates.
ABSOLUTE MAXIMUM RATINGS
(1)(2)
Supply Voltage ±30V
Input Voltage −V
EE
to V
CC
Operating Temperature 0°C to +70°C
Storage Temperature −65°C to +150°C
Junction Temperature 150°C
Power Dissipation
(3)
30W
Lead Temperature
(Soldering, 10 seconds) 260°C
ESD rating to be determined.
(1) Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for
which the device is functional, but do not ensure specific performance limits. Electrical Characteristics state DC and AC electrical
specifications under particular test conditions which ensure specific performance limits. This assumes that the device is within the
Operating Ratings. Specifications are not ensured for parameters where no limit is given, however, the typical value is a good indication
of device performance.
(2) If Military/Aerospace specified devices are required, please contact the Texas Instruments Sales Office/Distributors for availability and
specifications.
(3) Assumes T
A
equal to 70°C. For operation at higher tab temperatures, the LM675 must be derated based on a maximum junction
temperature of 150°C.
ELECTRICAL CHARACTERISTICS
V
S
=±25V, T
A
=25°C unless otherwise specified.
Parameter Conditions Typical Tested Limit Units
Supply Current P
OUT
= 0W 18 50 (max) mA
Input Offset Voltage V
CM
= 0V 1 10 (max) mV
Input Bias Current V
CM
= 0V 0.2 2 (max) μA
Input Offset Current V
CM
= 0V 50 500 (max) nA
Open Loop Gain R
L
= ∞Ω 90 70 (min) dB
PSRR ΔV
S
= ±5V 90 70 (min) dB
CMRR V
IN
= ±20V 90 70 (min) dB
Output Voltage Swing R
L
= 8Ω ±21 ±18 (min) V
Offset Voltage Drift Versus Temperature R
S
< 100 kΩ 25 μV/°C
Offset Voltage Drift Versus Output Power 25 μV/W
Output Power THD = 1%, f
O
= 1 kHz, R
L
= 8Ω 25 20 W
Gain Bandwidth Product f
O
= 20 kHz, A
VCL
= 1000 5.5 MHz
Max Slew Rate 8 V/μs
Input Common Mode Range ±22 ±20 (min) V
2 Submit Documentation Feedback Copyright © 1999–2013, Texas Instruments Incorporated
Product Folder Links: LM675