Datasheet

Table Of Contents

LM63

SNAS190E –SEPTEMBER 2002–REVISED MAY 2013

www.ti.com

PCB LAYOUT FOR MINIMIZING NOISE

Figure 16. Ideal Diode Trace Layout

In a noisy environment, such as a processor mother board, layout considerations are very critical. Noise induced

on traces running between the remote temperature diode sensor and the LM63 can cause temperature

conversion errors. Keep in mind that the signal level the LM63 is trying to measure is in microvolts. The following

guidelines should be followed:

1. Use a low-noise +3.3VDC power supply, and bypass to GND with a 0.1 µF ceramic capacitor in parallel with

a 100 pF ceramic capacitor. A bulk capacitance of 10 µF needs to be in the vicinity of the LM63's V

pin.

2. Place the100 pF power supply bypass capacitor as close as possible to the V

pin and the recommended

2.2 nF diode capacitor as close as possible to the LM63's D+ and D− pins. Make sure the traces to the

2.2 nF capacitor are matched.

3. Ideally, the LM63 should be placed within 10 cm of the Processor diode pins with the traces being as

straight, short and identical as possible. Trace resistance of 1 Ω can cause as much as 1°C of error. This

error can be compensated by using the Remote Temperature Offset Registers, since the value placed in

these registers will automatically be subtracted from or added to the remote temperature reading.

4. Diode traces should be surrounded by a GND guard ring to either side, above and below if possible. This

GND guard should not be between the D+ and D− lines. In the event that noise does couple to the diode

lines it would be ideal if it is coupled common mode. That is equally to the D+ and D− lines.

5. Avoid routing diode traces in close proximity to power supply switching or filtering inductors.

6. Avoid running diode traces close to or parallel to high-speed digital and bus lines. Diode traces should be

kept at least 2 cm apart from the high-speed digital traces.

7. If it is necessary to cross high-speed digital traces, the diode traces and the high-speed digital traces should

cross at a 90 degree angle.

8. The ideal place to connect the LM63's GND pin is as close as possible to the Processor's GND associated

with the sense diode.

9. Leakage current between D+ and GND should be kept to a minimum. One nano-ampere of leakage can

cause as much as 1°C of error in the diode temperature reading. Keeping the printed circuit board as clean

as possible will minimize leakage current.

Noise coupling into the digital lines greater than 400 mVp-p (typical hysteresis) and undershoot less than 500 mV

below GND, may prevent successful SMBus communication with the LM63. SMBus no acknowledge is the most

common symptom, causing unnecessary traffic on the bus. Although the SMBus maximum frequency of

communication is rather low (100 kHz max), care still needs to be taken to ensure proper termination within a

system with multiple parts on the bus and long printed circuit board traces. An RC lowpass filter with a 3 dB

corner frequency of about 40 MHz is included on the LM63's SMBCLK input. Additional resistance can be added

in series with the SMBData and SMBCLK lines to further help filter noise and ringing. Minimize noise coupling by

keeping digital traces out of switching power supply areas as well as ensuring that digital lines containing high-

speed data communications cross at right angles to the SMBData and SMBCLK lines.

Product Folder Links: LM63