Datasheet

LM5066
www.ti.com
SNVS655G JUNE 2011REVISED FEBRUARY 2013
STATUS_BYTE (78h)
The STATUS BYTE is a standard PMBus command that returns the value of a number of flags indicating the
state of the LM5066. Accesses to this command should use the PMBus read byte protocol. To clear bits in this
register, the underlying fault should be removed on the system and a CLEAR_FAULTS command issued.
Table 9. STATUS_BYTE Definitions
Bit NAME Meaning Default
7 BUSY Not Supported, always 0 0
6 OFF This bit is asserted if the MOSFET is not switched on 1
for any reason.
5 VOUT OV Not Supported, always 0 0
4 IOUT OC Not Supported, always 0 0
3 VIN UV Fault A VIN Under-voltage Fault has occurred 1
2 TEMPERATURE A Temperature Fault or Warning has occurred 0
1 CML A Communication Fault has occurred 0
0 None of the Above A fault or warning not listed in bits [7:1] has occurred 1
STATUS_WORD (79h)
The STATUS_WORD command is a standard PMBus command that returns the value of a number of flags
indicating the state of the LM5066. Accesses to this command should use the PMBus read word protocol. To
clear bits in this register, the underlying fault should be removed and a CLEAR _FAULTS command issued. The
INPUT and VIN UV flags will default to 1 on startup, however, they will be cleared to 0 after the first time the
input voltage exceeds the resistor-programmed UVLO threshold.
Table 10. STATUS_WORD Definitions
Bit NAME Meaning Default
15 VOUT An output voltage fault or warning has occurred 0
14 IOUT/POUT Not Supported, always 0 0
13 INPUT An input voltage or current fault has occurred 1
12 MFR A Manufacturer Specific Fault or Warning has occurred 1
11 POWER GOOD The Power Good signal has been negated 1
10 FANS Not Supported, always 0 0
9 OTHER Not Supported, always 0 0
8 UNKNOWN Not Supported, always 0 0
7 BUSY Not Supported, always 0 0
6 OFF This bit is asserted if the MOSFET is not switched on for 1
any reason.
5 VOUT OV Not Supported, always 0 0
4 IOUT OC Not Supported, always 0 0
3 VIN UV A VIN Under-voltage Fault has occurred 1
2 TEMPERATURE A Temperature Fault or Warning has occurred 0
1 CML A Communication Fault has occurred 0
0 None of the Above A fault or warning not listed in bits [7:1] has occurred 1
Copyright © 2011–2013, Texas Instruments Incorporated Submit Documentation Feedback 35
Product Folder Links: LM5066