Datasheet

HO1/LO2

HO2/LO1

SR1

SR2

Waveforms during soft-start

Waveforms after soft-start

T1 T2

CLK

T1 T2

Freewheel

Power

Transfer

LM5045

www.ti.com

SNVS699G –FEBRUARY 2011–REVISED MARCH 2013

A. Waveforms during Soft-Start

B. Waveforms after Soft-Start

Figure 16.

Pre-Bias Startup

A common requirement for power converters is to have a monotonic output voltage start-up into a pre-biased

load i.e. a pre-charged output capacitor. In a pre-biased load condition, if the synchronous rectifiers are engaged

prematurely they will sink current from the pre-charged output capacitors resulting in an undesired output voltage

dip. This condition is undesirable and could potentially damage the power converter. The LM5045 utilizes unique

control circuitry to ensure intelligent turn-on of the synchronous rectifiers such that the output has a monotonic

startup. Initially, the SSSR capacitor is held at ground to disable the synchronous MOSFETs allowing the body

diode to conduct. The synchronous rectifier soft-start is initiated once it is established the duty cycle is controlled

by the COMP instead of the soft-start capacitor i.e. I

COMP

< 800µA and the voltage at the SS pin>2V. The SSSR

capacitor is then released and is charged by a 20µA current source. Further, as shown in Figure 17, a 1V offset

on the SSSR pin is used to provide additional delay. This delay ensures the output voltage is in regulation

avoiding any reverse current when the synchronous MOSFETs are engaged.

Soft-Stop

As shown in Figure 18, if the UVLO pin voltage falls below the 1.25V standby threshold, but above the 0.4V

shutdown threshold, the SSSR capacitor is soft-stopped with a 60µA current source (3 times the charging

current). Once the SSSR pin reaches the 1.0V threshold, both the SS and SSSR pins are immediately

discharged to GND. Soft-stopping the power converter gradually winds down the energy in the output capacitors

and results in a monotonic decay of the output voltage. During the hiccup mode, the same sequence is executed

except that the SSSR is discharged with a 120µA current source (6 times the charging current). In case of an

OVP, VCC UV, thermal limit or a VREF UV condition, the power converter hard-stops, whereby all of the control

outputs are driven to a low state immediately.

Product Folder Links: LM5045