Datasheet

LM5030
SNVS215C –APRIL 2003–REVISED MARCH 2013 www.ti.com
OUT1, OUT2 and Time Delay
The LM5030 provides two alternating outputs, OUT1 and OUT2. The internal gate drivers can each sink 1.5A
peak each. The maximum duty cycle for each output is inherently limited to less than 50%. The typical deadtime
between the falling edge of one gate driver output and the rising edge of the other gate driver output is 135ns.
Thermal Protection
Internal Thermal Shutdown circuitry is provided to protect the integrated circuit in the event the excessive
junction temperature. When activated, typically at 165 degrees Celsius, the controller is forced into a low power
reset state, disabling the output drivers and the bias regulator. This feature is provided to prevent catastrophic
failures from accidental device overheating.
Typical Application Circuit
Figure 10. Typical Application Circuit, 36V - 75VIN and 3.3V, 10A OUT
10 Submit Documentation Feedback Copyright © 2003–2013, Texas Instruments Incorporated
Product Folder Links: LM5030