Datasheet

LM4995, LM4995TMBD
www.ti.com SNAS329G –APRIL 2006–REVISED APRIL 2013
ABSOLUTE MAXIMUM RATINGS
(1)(2)
Supply Voltage
(3)
6.0V
Storage Temperature −65°C to +150°C
Input Voltage −0.3V to V
DD
+0.3V
Power Dissipation
(4)(5)
Internally Limited
ESD Susceptibility
(6)
2000V
ESD Susceptibility
(7)
200V
Junction Temperature 150°C
Thermal Resistance θ
JA
(DSBGA) 96.5°C/W
θ
JA
(WSON) 56°C/W
(1) Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for
which the device is functional, but do not ensure specific performance limits. Electrical Characteristics state DC and AC electrical
specifications under particular test conditions which ensure specific performance limits. This assumes that the device is within the
Operating Ratings. Specifications are not ensure for parameters where no limit is given, however, the typical value is a good indication
of device performance.
(2) If Military/Aerospace specified devices are required, please contact the Texas Instruments Sales Office/ Distributors for availability and
specifications.
(3) If the product is in Shutdown mode and V
DD
exceeds 6V (to a max of 8V V
DD
), then most of the excess current will flow through the
ESD protection circuits. If the source impedance limits the current to a max of 10mA, then the device will be protected. If the device is
enabled when V
DD
is greater than 5.5V and less than 6.5V, no damage will occur, although operation life will be reduced. Operation
above 6.5V with no current limit will result in permanent damage.
(4) The maximum power dissipation must be derated at elevated temperatures and is dictated by T
JMAX
, θ
JA
, and the ambient temperature
T
A
. The maximum allowable power dissipation is P
DMAX
= (T
JMAX
–T
A
)/θ
JA
or the number given in Absolute Maximum Ratings, whichever
is lower. For the LM4995, see power derating curves for additional information.
(5) Maximum power dissipation in the device (P
DMAX
) occurs at an output power level significantly below full output power. P
DMAX
can be
calculated using Equation 1 shown in the APPLICATION INFORMATION section. It may also be obtained from the power dissipation
graphs.
(6) Human body model, 100pF discharged through a 1.5kΩ resistor.
(7) Machine Model, 220pF–240pF discharged through all pins.
OPERATING RATINGS
Temperature Range (T
MIN
≤ T
A
≤ T
MAX
) −40°C ≤ T
A
≤ 85°C
Supply Voltage 2.4V ≤ V
DD
≤ 5.5V
Copyright © 2006–2013, Texas Instruments Incorporated Submit Documentation Feedback 3
Product Folder Links: LM4995 LM4995TMBD