Datasheet

LM4819, LM4819MBD
SNAS133D –FEBRUARY 2001–REVISED MARCH 2013 www.ti.com
Figure 26. Higher Gain Audio Amplifier
The LM4819 is unity-gain stable and requires no external components besides gain-setting resistors, an input
coupling capacitor, and proper supply bypassing in the typical application. However, if a closed-loop differential
gain of greater than 10 is required, a feedback capacitor (C
4
) may be needed as shown in Figure 26 to
bandwidth limit the amplifier. This feedback capacitor creates a low pass filter that eliminates possible high
frequency oscillations. Care should be taken when calculating the -3dB frequency in that an incorrect
combination of R
3
and C
4
will cause rolloff before 20kHz. A typical combination of feedback resistor and
capacitor that will not produce audio band high frequency rolloff is R
3
= 20kΩ and C
4
= 25pF. These components
result in a -3dB point of approximately 320 kHz. It is not recommended that the feedback resistor and capacitor
be used to implement a band limiting filter below 100kHz.
Figure 27. Differential Amplifier Configuration for LM4819
14 Submit Documentation Feedback Copyright © 2001–2013, Texas Instruments Incorporated
Product Folder Links: LM4819 LM4819MBD