Datasheet

21.2.3 Signals by Function, Except for GPIO
Table 21-7. Signals by Function, Except for GPIO
DescriptionBuffer Type
a
Pin TypePin NumberPin NameFunction
Analog-to-digital converter input 0.AnalogIB1ADC0
ADC
Analog-to-digital converter input 1.AnalogIA1ADC1
Analog-to-digital converter input 2.AnalogIB3ADC2
Analog-to-digital converter input 3.AnalogIB2ADC3
Analog comparator 0 positive input.AnalogIA7C0+
Analog Comparators
Analog comparator 0 negative input.AnalogIA6C0-
Analog comparator 0 output.TTLOB7C0o
CAN module 0 receive.TTLIG1CAN0Rx
Controller Area
Network
CAN module 0 transmit.TTLOG2CAN0Tx
12.4-kΩ resistor (1% precision) used internally for
Ethernet PHY.
AnalogIK3ERBIAS
Ethernet
GND of the Ethernet PHY.Power-C8
C9
K4
GNDPHY
Ethernet LED 0.TTLOJ12LED0
Ethernet LED 1.TTLOJ11LED1
MDIO of the Ethernet PHY.TTLI/OL9MDIO
RXIN of the Ethernet PHY.AnalogIL7RXIN
RXIP of the Ethernet PHY.AnalogIM7RXIP
TXON of the Ethernet PHY.AnalogOL8TXON
TXOP of the Ethernet PHY.AnalogOM8TXOP
VCC of the Ethernet PHY.Power-C10
D10
D11
VCCPHY
Ethernet PHY XTALN 25-MHz oscillator crystal
output. Connect this pin to ground when using a
single-ended 25-MHz clock input connected to the
XTALPPHY pin.
TTLOJ1XTALNPHY
Ethernet PHY XTALP 25-MHz oscillator crystal
input or external clock reference input.
TTLIJ2XTALPPHY
Capture/Compare/PWM 0.TTLI/OE1CCP0
General-Purpose
Timers
Capture/Compare/PWM 1.TTLI/OL6CCP1
June 18, 2012740
Texas Instruments-Production Data
Signal Tables
NRND: Not recommended for new designs.