Datasheet
Register 7: GPTM Masked Interrupt Status (GPTMMIS), offset 0x020
This register show the state of the GPTM's controller-level interrupt. If an interrupt is unmasked in
GPTMIMR, and there is an event that causes the interrupt to be asserted, the corresponding bit is
set in this register. All bits are cleared by writing a 1 to the corresponding bit in GPTMICR.
GPTM Masked Interrupt Status (GPTMMIS)
Timer0 base: 0x4003.0000
Timer1 base: 0x4003.1000
Timer2 base: 0x4003.2000
Timer3 base: 0x4003.3000
Offset 0x020
Type RO, reset 0x0000.0000
16171819202122232425262728293031
reserved
ROROROROROROROROROROROROROROROROType
0000000000000000Reset
0123456789101112131415
TATOMISCAMMISCAEMISRTCMISreservedTBTOMISCBMMISCBEMISreserved
ROROROROROROROROROROROROROROROROType
0000000000000000Reset
DescriptionResetTypeNameBit/Field
Software should not rely on the value of a reserved bit. To provide
compatibility with future products, the value of a reserved bit should be
preserved across a read-modify-write operation.
0x00ROreserved31:11
GPTM CaptureB Event Masked Interrupt
This is the CaptureB event interrupt status after masking.
0ROCBEMIS10
GPTM CaptureB Match Masked Interrupt
This is the CaptureB match interrupt status after masking.
0ROCBMMIS9
GPTM TimerB Time-Out Masked Interrupt
This is the TimerB time-out interrupt status after masking.
0ROTBTOMIS8
Software should not rely on the value of a reserved bit. To provide
compatibility with future products, the value of a reserved bit should be
preserved across a read-modify-write operation.
0x0ROreserved7:4
GPTM RTC Masked Interrupt
This is the RTC event interrupt status after masking.
0RORTCMIS3
GPTM CaptureA Event Masked Interrupt
This is the CaptureA event interrupt status after masking.
0ROCAEMIS2
GPTM CaptureA Match Masked Interrupt
This is the CaptureA match interrupt status after masking.
0ROCAMMIS1
GPTM TimerA Time-Out Masked Interrupt
This is the TimerA time-out interrupt status after masking.
0ROTATOMIS0
June 18, 2012360
Texas Instruments-Production Data
General-Purpose Timers
NRND: Not recommended for new designs.