Datasheet

DescriptionResetTypeNameBit/Field
GPTM RTC Enable
The RTCEN values are defined as follows:
DescriptionValue
RTC counting is disabled.0
RTC counting is enabled.1
0R/WRTCEN4
GPTM TimerA Event Mode
The TAEVENT values are defined as follows:
DescriptionValue
Positive edge0x0
Negative edge0x1
Reserved0x2
Both edges0x3
0x0R/WTAEVENT3:2
GPTM Timer A Stall Enable
The TASTALL values are defined as follows:
DescriptionValue
Timer A continues counting while the processor is halted by the
debugger.
0
Timer A freezes counting while the processor is halted by the
debugger.
1
If the processor is executing normally, the TASTALL bit is ignored.
0R/WTASTALL1
GPTM TimerA Enable
The TAEN values are defined as follows:
DescriptionValue
TimerA is disabled.0
TimerA is enabled and begins counting or the capture logic is
enabled based on the GPTMCFG register.
1
0R/WTAEN0
June 18, 2012356
Texas Instruments-Production Data
General-Purpose Timers
NRND: Not recommended for new designs.