Datasheet

Register 5: Interrupt 32-43 Set Enable (EN1), offset 0x104
Note: This register can only be accessed from privileged mode.
The EN1 register enables interrupts and shows which interrupts are enabled. Bit 0 corresponds to
Interrupt 32; bit 11 corresponds to Interrupt 43. See Table 2-9 on page 86 for interrupt assignments.
If a pending interrupt is enabled, the NVIC activates the interrupt based on its priority. If an interrupt
is not enabled, asserting its interrupt signal changes the interrupt state to pending, but the NVIC
never activates the interrupt, regardless of its priority.
Interrupt 32-43 Set Enable (EN1)
Base 0xE000.E000
Offset 0x104
Type R/W, reset 0x0000.0000
16171819202122232425262728293031
reserved
ROROROROROROROROROROROROROROROROType
0000000000000000Reset
0123456789101112131415
INTreserved
R/WR/WR/WR/WR/WR/WR/WR/WR/WR/WR/WR/WROROROROType
0000000000000000Reset
DescriptionResetTypeNameBit/Field
Software should not rely on the value of a reserved bit. To provide
compatibility with future products, the value of a reserved bit should be
preserved across a read-modify-write operation.
0x0000.0ROreserved31:12
Interrupt Enable
DescriptionValue
On a read, indicates the interrupt is disabled.
On a write, no effect.
0
On a read, indicates the interrupt is enabled.
On a write, enables the interrupt.
1
A bit can only be cleared by setting the corresponding INT[n] bit in
the DIS1 register.
0x000R/WINT11:0
June 18, 2012114
Texas Instruments-Production Data
Cortex-M3 Peripherals
NRND: Not recommended for new designs.