Datasheet

L1 =
V
OUT
x (V
IN
- V
OUT
)
I
OR
x F
S
x V
IN
R
ON
200 ns x V
INMAX
t
1.3 x 10
-10
LM34910C
SNVS517B –MAY 2007–REVISED MARCH 2013 www.ti.com
APPLICATIONS INFORMATION
EXTERNAL COMPONENTS
The following guidelines can be used to select the external components.
R1 and R2: The ratio of these resistors is calculated from:
R1/R2 = (V
OUT
/2.5V) - 1 (8)
R1 and R2 should be chosen from standard value resistors in the range of 1.0 kΩ - 10 kΩ which satisfy the
above ratio.
R
ON
: The minimum value for R
ON
is calculated from:
(9)
Equation 1 can be used to select R
ON
if a specific frequency is desired as long as the above limitation is met.
L1: The main parameter affected by the inductor is the output current ripple amplitude (I
OR
). The limits for I
OR
must be determined at both the minimum and maximum nominal load currents.
a) If the maximum load current is less than the current limit threshold (1.25A), the minimum load current is used
to determine the maximum allowable ripple. To maintain continuous conduction mode the lower peak should not
reach 0 mA. For this case, the maximum ripple current is:
I
OR(MAX1)
= 2 x I
O(min)
(10)
The ripple calculated in Equation 6 is then used in the following equation:
where
• V
IN
is the maximum input voltage
• Fs is determined from Equation 1 (11)
This provides a minimum value for L1. The next larger standard value should be used, and L1 should be rated
for the I
PK
current level.
b) If the maximum load current is greater than the current limit threshold (1.25A), the LM34910C ensures the
lower peak reaches 1.25A each cycle, requiring that I
OR
be at least twice the difference. The upper peak,
however, must not exceed 3.5A. For this case, the ripple limits are:
I
OR(MAX2)
= 2 x (3.5A - I
O(max)
) (12)
and
I
OR(MIN1)
= 2 x (I
O(max)
- 1.25A) (13)
The lesser of Equation 12 and Equation 13 is then used in Equation 11. If I
OR(MAX2)
is used, the maximum V
IN
is
used in Equation 11. The next larger value should then be used for L1. If I
OR(MIN1)
is used, the minimum V
IN
is
used in Equation 11. The next smaller value should then be used for L1. L1 must be rated for the peak value of
the current waveform (I
PK
in Figure 6).
C3: The capacitor on the V
CC
output provides not only noise filtering and stability, but also prevents false
triggering of the V
CC
UVLO at the buck switch on/off transitions. For this reason, C3 should be no smaller than
0.1 µF, and should be a good quality, low ESR, ceramic capacitor.
10 Submit Documentation Feedback Copyright © 2007–2013, Texas Instruments Incorporated
Product Folder Links: LM34910C