Datasheet

SW
1
RON
2
VIN
3
BOOT
4
VCC
8
GND
7
DIM
6
CS
5
SW
1
RON
2
VIN
3
BOOT
4
VCC
8
GND
7
DIM
6
CS
5
DAP
LM3402, LM3402HV
SNVS450E –SEPTEMBER 2006–REVISED MAY 2013 www.ti.com
Connection Diagram
Figure 1. 8-Lead Plastic VSSOP-8 Package Figure 2. 8-Lead Plastic SO PowerPAD-8 Package
See Package Number DGK (S-PDSO-G8) See Package Number DDA0008B
PIN DESCRIPTIONS
Pin(s) Name Description Application Information
1 SW Switch pin Connect this pin to the output inductor and Schottky diode.
2 BOOT MOSFET drive bootstrap pin Connect a 10 nF ceramic capacitor from this pin to SW.
3 DIM Input for PWM dimming Connect a logic-level PWM signal to this pin to enable/disable the power FET and
reduce the average light output of the LED array.
4 GND Ground pin Connect this pin to system ground.
5 CS Current sense feedback pin Set the current through the LED array by connecting a resistor from this pin to
ground.
6 RON On-time control pin A resistor connected from this pin to VIN sets the regulator controlled on-time.
7 VCC Output of the internal 7V linear Bypass this pin to ground with a minimum 0.1 µF ceramic capacitor with X5R or
regulator X7R dielectric.
8 VIN Input voltage pin Nominal operating input range is 6V to 42V (LM3402) or 6V to 75V (LM3402HV).
DAP GND Thermal Pad Connect to ground. Place 4 to 6 vias from DAP to bottom layer ground plane.
2 Submit Documentation Feedback Copyright © 2006–2013, Texas Instruments Incorporated
Product Folder Links: LM3402 LM3402HV