Datasheet

Operating the Evaluation Board www.ti.com
Figure 1. LM2651_EVAL Schematic for Adjustable Voltage
Table 1. Bill of Materials
Ref Designator Part Description Part Number
U1 IC LM2651MTC-3.3 LM2651MTC-3.3
L1 Inductor Coilcraft DO3316P-223
CIN Tan Cap 100 µF 16 V 10% Size = D Vishay 594D107X0016D2T
CSS Cer Cap 4.7 nF 50 V X7R 10% 1206 Vishay VJ1206Y472KXAMB
CC2 Cer Cap 100 pF 50 V NPO 1206 Vishay VJ1206A101JXAMB
CC1 Cer Cap 2.2 nF 50 V X7R 10% 1206 Vishay VJ1206Y222KXAMB
COUT Tant Cap 120 µF 6.3 V 10% Size = D Vishay 594D127X06R3C2T
CIN2 Cer Cap 0.1 µF 50 V X7R 10% 0805 Vishay VJ0805Y104KXAMB
CB Cer Cap 0.1 µF 50 V X7R 10% 0805 Vishay VJ0805Y104KXAMB
R1 Res 0.1 Ω ⅛W 5% LR series 0805 Vishay CRCW0805R100JTGLR
R2 Open
RC Res 30.0 kΩ ⅛W 5% 0805 Vishay CRCW0805303J
D1 Schottky Diode 1A SMA Motorola MBRA130LT3
3 Operating the Evaluation Board
3.1 Setup
The LM2651_3.3V_EVAL evaluation board comes ready to be tested. The only setup needed is
connecting the input voltage to the V
IN
and GND posts. The load and output are connected to the V
OUT
post.
3.2 Operating Conditions
The input voltage to the LM2651-3.3 regulator must be within the range of 4 V to 14 V DC for proper
operation. The device will not function properly with voltages below 4 V and damage may occur if any
voltage greater than 16 V is applied.
2
AN–1143 LM2651_3.3V_EVAL 1.5A High Efficiency Synchronous Switching SNVA015C–February 2000–Revised April 2013
Regulator Evaluation Board
Submit Documentation Feedback
Copyright © 2000–2013, Texas Instruments Incorporated