Datasheet

Evaluation Kit Setup
www.ti.com
Figure 2. Feedback Network Locations
3 Evaluation Kit Setup
Please use ESD protection to prevent any unwanted damaging ESD events!
The user of the LM26480 Evaluation Board can leave the regulator outputs as is or can change them at
any time. In order to change them, remove the existing feedback network and reconfigure it using the
optimal resistors and capacitors for a designated output voltage which can be chosen from Table 1 and
Table 2.
4 Cautionary Notes
Turrets may be placed somewhat close together on the board. Be careful not to short adjacent pins to
each other!
2
AN-1800 Evaluation Kit for LM26480 - Dual DC/DC Buck Regulators with SNVA329DMarch 2008Revised April 2013
Dual Low-Noise Linear Regulators
Submit Documentation Feedback
Copyright © 2008–2013, Texas Instruments Incorporated