Datasheet

LM2621

SNVS033C –MAY 2004–REVISED MARCH 2005

www.ti.com

DETAILED DESCRIPTION

OPERATING PRINCIPLE

The LM2621 is designed to provide step-up DC-DC voltage regulation in battery-powered and low-input voltage

systems. It combines a step-up switching regulator, N-channel power MOSFET, built-in current limit, thermal

limit, and voltage reference in a single 8-pin VSSOP package Figure 13. The switching DC-DC regulator boosts

an input voltage between 1.2V and 14V to a regulated output voltage between 1.24V and 14V. The LM2621

starts from a low 1.1V input and remains operational down to 0.65V.

This device is optimized for use in cellular phones and other applications requiring a small size, low profile, as

well as low quiescent current for maximum battery life during stand-by and shutdown. A high-efficiency gated-

oscillator topology offers an output of up to 1A.

Additional features include a built-in peak switch current limit, and thermal protection circuitry.

Figure 13. Functional Diagram

GATED OSCILLATOR CONTROL SCHEME

A unique gated oscillator control scheme enables the LM2621 to have an ultra-low quiescent current and

provides a high efficiency over a wide load range. The switching frequency of the internal oscillator is

programmable using an external resistor and can be set between 300 kHz and 2 MHz.

This control scheme uses a hysteresis window to regulate the output voltage. When the output voltage is below

the upper threshold of the window, the LM2621 switches continuously with a fixed duty cycle of 70% at the

switching frequency selected by the user. During the first part of each switching cycle, the internal N-channel

MOSFET switch is turned on. This causes the current to ramp up in the inductor and store energy. During the

second part of each switching cycle, the MOSFET is turned off. The voltage across the inductor reverses and

forces current through the diode to the output filter capacitor and the load. Thus when the LM2621 switches

continuously, the output voltage starts to ramp up. When the output voltage hits the upper threshold of the

window, the LM2621 stops switching completely. This causes the output voltage to droop because the energy

stored in the output capacitor is depleted by the load. When the output voltage hits the lower threshold of the

hysteresis window, the LM2621 starts switching continuously again causing the output voltage to ramp up

towards the upper threshold. Figure 14 shows the switch voltage and output voltage waveforms.

Product Folder Links: LM2621