Datasheet

LM20134, LM20134Q

SNVS527G –OCTOBER 2007–REVISED MARCH 2013

www.ti.com

It is important to always keep the operating junction temperature (T

) below 125°C for reliable operation. If the

junction temperature exceeds 160°C the device will cycle in and out of thermal shutdown. If thermal shutdown

occurs it is a sign of inadequate heatsinking or excessive power dissipation in the device.

Figure 35, shown below, provides a better approximation of the θ

for a given PCB copper area. The PCB

heatsink area consists of 2oz. copper located on the bottom layer of the PCB directly under the HTSSOP

exposed pad. The bottom copper area is connected to the HTSSOP exposed pad by means of a 4 x 4 array of

12 mil thermal vias.

Figure 35. Thermal Resistance vs PCB Area

PCB LAYOUT CONSIDERATIONS

PC board layout is an important part of DC-DC converter design. Poor board layout can disrupt the performance

of a DC-DC converter and surrounding circuitry by contributing to EMI, ground bounce, and resistive voltage loss

in the traces. These can send erroneous signals to the DC-DC converter resulting in poor regulation or instability.

Good layout can be implemented by following a few simple design rules.

1. Minimize area of switched current loops. In a buck regulator there are two loops where currents are switched

very fast. The first loop starts from the input capacitor, to the regulator VIN pin, to the regulator SW pin, to

the inductor then out to the output capacitor and load. The second loop starts from the output capacitor

ground, to the regulator PGND pins, to the inductor and then out to the load (see Figure 36). To minimize

both loop areas the input capacitor should be placed as close as possible to the PVIN pin. Grounding for

both the input and output capacitor should consist of a small localized top side plane that connects to PGND

and the die attach pad (DAP). The inductor should be placed as close as possible to the SW pin and output

capacitor.

2. Minimize the copper area of the switch node. Since the LM20134 has the SW pins on opposite sides of the

package it is recommended to via these pins down to the bottom or internal layer with 2 to 4 vias on each

SW pin. The SW pins should be directly connected with a trace that runs across the bottom of the package.

To minimize IR losses this trace should be no smaller that 50 mils wide, but no larger than 100 mils wide to

keep the copper area to a minimum. In general the SW pins should not be connected on the top layer since it

could block the ground return path for the power ground. The inductor should be placed as close as possible

to one of the SW pins to further minimize the copper area of the switch node.

3. Have a single point ground for all device analog grounds located under the DAP. The ground connections for

the compensation, feedback, and Soft-Start components should be connected together then routed to the

AGND pin of the device. The AGND pin should connect to PGND under the DAP. This prevents any

switched or load currents from flowing in the analog ground plane. If not properly handled poor grounding

can result in degraded load regulation or erratic switching behavior.

4. Minimize trace length to the FB pin. Since the feedback node can be high impedance the trace from the

output resistor divider to FB pin should be as short as possible. This is most important when high value

resistors are used to set the output voltage. The feedback trace should be routed away from the SW pin and

inductor to avoid contaminating the feedback signal with switch noise.

Product Folder Links: LM20134 LM20134Q