Datasheet

www.ti.com

LM10011 Control and Design Software

9.5 Output Voltage

After modifying the evaluation board with the new design values, the user can then use the GUI to change

the output voltage. The Output Voltage section, Figure 11, allows the user to change the output voltage to

any voltage within the range specified by VOUT MIN and VOUT MAX in the Resistor and Vout Values

(Calculated) section. Enter the desired VOUT in the Nominal Vout spin box. The closest available Nominal

VOUT will be chosen in the NOM VOUT (Actual) Section

The Present Vout box will show what the current state of the output voltage is. The value in this box will

match the "(Present VOUT)" box in the schematic. This value will change on the users margining input.

Figure 11. Output Voltage Section

SNOU108A–December 2012–Revised April 2013 LM10011 Evaluation Module

Submit Documentation Feedback