Datasheet

Control Software

www.ti.com

Figure 5. LM10010 Board Values Tab

10.3 Select Operation

Once the board values are set (or the defaults are chosen), the user can choose the mode of operation of

the evaluation module. In the Select Operation Panel, shown in Figure 6, Set Static Voltage or Set

Dynamic Voltage can be chosen by clicking on either button. By making a selection, this will reveal the

appropriate control panel for the mode of operation.

Figure 6. LM10010 Select Operation Panel

10.4 Set Static Voltage

The first mode of operation is used to set a static voltage from the point of load. Based on the resistors

from the Board Values section, the user can input a voltage and set the output voltage to a desired level.

Also, a percentage of margin can be entered and the code can be incremented by the margin percentage

up or down dependent on the nearest code value available. The Set Static Voltage panel, with controls

entering in the voltage, margin percentage, and buttons to margin up or down the output can be seen in

Figure 7.

AN-2176 LM10010 Evaluation Board SNVA498B–July 2011–Revised May 2013

Submit Documentation Feedback