User Manual

Manuals
For detailed specification on each item in the LF Micro Reader
Evaluation Kit please refer to the documentation provided on the CD
included with this kit, or look inside the -Document Center- on our
RFID Systems Web Site at: http://www.ti-rfid.com
1. Series 2000 Reader System, Reference Guide 11-06-21-027
Micro-reader RI-STU-MRD1
2. Series 2000 Micro Reader, Data Sheet 11-06-22-069
Micro-reader RI-STU-MRD1
The LF Micro Reader Evaluation kit comprises a RF transmission
device, and is therefore subject to national and international regula-
tions. TI has obtained approvals from approval authorities in a
number of countries and is continuing to apply for approvals in fur-
ther countries. Actual status can be advised by customer support. In
countries where approval has not been obtained, this system may be
operated only under an experimental license issued by the relevant
approval authority and must not be marketed. Before any such
device or system can be marketed, an equipment authorization must
be obtained from the relevant approval authority.
FCC Notices (U.S.A.)
The Federal Communications Commission, FCC, has imposed
approval requirements on all intentional radiator equipment. This TI
product complies with FCC rules Part 15, Subpart C, "Intentional
Radiator" Paragraph 15.207 "Conducted Limits" and 15.209 "Radiated
Emissions Limits; General Requirements". FCC certification is
required for systems and the customer is responsible for meeting
those restrictions and obtaining approval for their system from the
FCC. The intentional radiators are labeled according to the FCC with
the following label:
6
6. References
7. Regulations
Getting Started MicroReader 12/6/01 4:13 PM Page 9