User Manual

The Micro Reader is packed in a special antistatic bag to protect it
from static charge that could cause damage.
• Handle the Micro Reader carefully and keep it in the protective
envelope until you are ready to install it.
• Whenever possible, handle the Micro Reader by its edges or frame.
4.1 Interface Cable
• Connect the serial data cable (11) with the serial interface connector
mounted on the control board of the S2000 microreader (10).
• Connect the 9-pin DB plug of the serial data cable (11) to the serial
port of a computer.
4.2 Power Supply
• Connect the output connector of the Power Supply (13) to the
reader interface board and connect the power supply to Main Power.
• The red LED on the reader should be flashing.
4.3 Software Installation
System requirements:
• 5MB available space on hard disk
• Windows 95, 98, NT, 2000
The software TIRIS Reader Manager S2_UTIL Version 1.20 can be
downloaded from the resource CD under the directory "Software" or
the website at:
http://www.ti.com/tiris/docs/products/tools.htm
S2_UTIL Version 1.2 is a Windows based software utility program
for the configuration and demonstration of our Series 2000 readers.
4. Installation
4
3. ESD Safety Information
Caution:
The input tip on the power supply must be set at positive tip
or interior output voltage. TI warranty does not cover damage
to the reader unit caused by reverse voltage polarity. Check
that the arrow on the tip of the power supply is lined up with
the (-) setting on the power supply output barrel for negative
barrel but positive tip voltage.
Getting Started MicroReader 12/6/01 4:12 PM Page 7