Datasheet

Copyright © 2014–2016, Texas Instruments Incorporated Terminal Configuration and Functions
Submit Documentation Feedback
Product Folder Links: RM57L843
41
RM57L843
www.ti.com SPNS215C –FEBRUARY 2014–REVISED JUNE 2016
4.2.1.19 Test and Debug Modules Interface
Table 4-21. ZWT Test and Debug Modules Interface
TERMINAL
SIGNAL
TYPE
DEFAULT
PULL STATE
PULL TYPE
OUTPUT
BUFFER
DRIVE
STRENGTH
DESCRIPTION
SIGNAL NAME
337
ZWT
nTRST D18 Input Pulldown 100 µA - JTAG test hardware reset
TCK B18 Input Pulldown Fixed, 100 µA - JTAG test clock
TDI A17 Input Pullup Fixed, 100 µA - JTAG test data in
TDO C18 Output Pulldown Fixed, 100 µA 8mA JTAG test data out
TEST U2 Input Pulldown Fixed, 100 µA -
Test mode enable. This terminal
must be connected to ground directly
or through a pulldown resistor.
TMS C19 Input Pullup Fixed, 100 µA - JTAG test mode select
RTCK A16 Output - - 8mA JTAG return test clock
4.2.1.20 Flash Supply and Test Pads
Table 4-22. ZWT Flash Supply and Test Pads
TERMINAL
SIGNAL
TYPE
DEFAULT
PULL STATE
PULL TYPE
OUTPUT
BUFFER
DRIVE
STRENGTH
DESCRIPTION
SIGNAL NAME
337
ZWT
VCCP F8 3.3-V Power – – – Flash pump supply
FLTP1 J5 Input – – – Flash test pads. These terminals are
reserved for TI use only. For proper
operation these terminals must
connect only to a test pad or not be
connected at all [no connect (NC)].
FLTP2 H5 Input – – –