Datasheet

I2C Control Registers www.ti.com
30.6.25.1 Summary
The behavior of the input buffer, output buffer, and the pull control is summarized in Table 30-35.
Table 30-35. Input Buffer, Output Buffer, and Pull Control Behavior as GPIO Pins
Device
under Pin Direction Pull Disable Pull Select
Reset? (DIR)
(1)(2)
(PULDIS)
(1)(3)
(PULSEL)
(1)(4)
Pull Control Output Buffer Input Buffer
Yes X X X Device-specific, check Disabled Enabled
device datasheet
No 0 0 0 Pull down Disabled Enabled
No 0 0 1 Pull up Disabled Enabled
No 0 1 0 Disabled Disabled Enabled
No 0 1 1 Disabled Disabled Enabled
No 1 X X Disabled Enabled Enabled
(1)
X = Don’t care
(2)
DIR = 0 for input, 1 for output
(3)
PULDIS = 0 for enabling pull control
= 1 for disabling pull control
(4)
PULSEL= 0 for pull-down functionality
= 1 for pull-up functionality
30.6.26 I2C Pins Slew Rate Select Register (I2CSRS)
This register controls the slew rate of the signal on the I2C pins. Figure 30-39 and Table 30-36 describe
this register.
Figure 30-39. I2C Pins Slew Rate Select Register (I2CSRS) [offset = 6Ch]
15 2 1 0
Reserved SDASRS SCLSRS
R-0 R/W-0 R/W-0
LEGEND: R/W = Read/Write; R = Read only; -n = value after reset
Table 30-36. I2C Pins Slew Rate Select Register (I2CSRS) Field Descriptions
Bit Field Value Description
15-2 Reserved 0 Read returns 0. Writes have no effect.
1 SDASRS SDA Slew Rate select
0 The slow buffer is selected.
1 The normal buffer is selected.
0 SCLSRS SCL Slew Rate select
0 The slow buffer is selected.
1 The normal buffer is selected.
1522
Inter-Integrated Circuit (I2C) Module SPNU562–May 2014
Submit Documentation Feedback
Copyright © 2014, Texas Instruments Incorporated