Datasheet

Control Registers www.ti.com
27.3.30 Transfer Group Interrupt Flag Register (TGINTFLAG)
The TGINTFLAG register comprises the transfer group interrupt flags for transfer-completed interrupts
(INTFLGRDYx) and for transfer-suspended interrupts (INTFLGSUSx). Each of the interrupt flags in the
higher half-word and the lower half-word of TGINTFLAG belongs to one TG.
The register map shown in Figure 27-65 and Table 27-38 represents a super-set device with the
maximum number of TGs (16) assumed. The actual number of bits available varies per device.
Figure 27-65. Transfer Group Interrupt Flag Register (TGINTFLAG) [offset = 84h]
31 16
INTFLGRDY
R/WC-0
15 0
INTFLGSUS
R/WC-0
LEGEND: R/W = Read/Write; R = Read only; C = Clear; -n = value after reset
Table 27-38. Transfer Group Interrupt Level Clear Register (TGITLVCR) Field Descriptions
Bit Field Value Description
31-16 INTFLGRDY Transfer-group interrupt flag for a transfer-completed interrupt.
Note: Read Clear Behavior. Reading the interrupt vector registers TGINTVECT0 or TGINTVECT1
automatically clears the interrupt flag bit INTFLGRDYx referenced by the vector number given by
INTVECT0/INTVECT1 bits, if the SUSPEND[0:1] bit in the vector registers is 0.
0 Read: No transfer-completed interrupt occurred since last clearing of the INTFLGRDYx flag.
Write: A write of 0 to this bit has no effect.
1 Read: A transfer finished interrupt from transfer group x occurred. No matter whether the interrupt is
enabled or disabled (INTENRDYx = don't care) or whether the interrupt is mapped to INT0 or INT1,
INTFLGRDYx is set right after the transfer from TGx is finished.
Write: The corresponding bit flag is cleared.
15-0 INTFLGSUS Transfer-group interrupt flag for a transfer-suspend interrupt.
Note: Read Clear Behavior. Reading the interrupt vector registers TGINTVECT0 or TGINTVECT1
automatically clears the interrupt flag bit INTFLGSUSx referenced by the vector number given by
INTVECT0/INTVECT1 bits, if the SUSPEND[0:1] bit in the corresponding vector registers is 1.
0 Read: No transfer-suspended interrupt occurred since the last clearing of the INTFLGSUSx flag.
Write: A write of 0 to this bit has no effect.
1 Read: A transfer-suspended interrupt from TGx occurred. No matter whether the interrupt is enabled or
disabled (INTENSUSx = don't care) or whether the interrupt is mapped to INT0 or INT1, INTFLGSUSx
is set right after the transfer from transfer group x is suspended.
Write: The corresponding bit flag is cleared.
1302
Multi-Buffered Serial Peripheral Interface Module (MibSPI) with Parallel Pin SPNU562–May 2014
Option (MibSPIP)
Submit Documentation Feedback
Copyright © 2014, Texas Instruments Incorporated