Datasheet

www.ti.com HTU Control Registers
24.4.13 Interrupt Offset Register 1 (HTU INTOFF1)
This register is organized identically to the INTOFF0 register. The difference is that INTOFF1 reflects the
highest priority interrupt flag bit set in the BERINTFL, RLOSTFL or BFINTFL flag registers with the
appropriate CPINTMAP bit set to 1.
Figure 24-26. Interrupt Offset Register 1 (HTU INTOFF1) [offset = 38h]
31 16
Reserved
R-0
15 10 9 8 7 4 3 1 0
Reserved INTTYPE1 Reserved CPOFF1
R-0 R-0 R-0 R-0
LEGEND: R/W = Read/Write; R = Read only; -n = value after reset
Table 24-25. Interrupt Offset Register 1 (HTU INTOFF1) Field Descriptions
Bit Field Value Description
31-11 Reserved 0 Read returns 0. Writes have no effect.
10-8 INTTYPE1 Interrupt Type of Interrupt Line 1. Indicates whether a buffer-full, RLOST or BER interrupt -
assigned to interrupt line 1 - is currently pending.
0 No interrupt
1h Interrupt caused by full buffer on CP/DCP specified by CPOFF1
2h RLOST interrupt generated by CP/DCP specified by CPOFF1
3h BER interrupt generated by CP/DCP specified by bits CPOFF1
7-5 Reserved 0 Read returns 0. Writes have no effect.
4-0 CPOFF1 CP Offset. Indicates for which DCP / CP the interrupt is pending, which is classified by INTTYPE1
and is assigned to interrupt line 1
0 DCP 0, CP A
1h DCP 0, CP B
2h DCP 1, CP A
3h DCP 1, CP B
4h DCP 2, CP A
5h DCP 2, CP B
6h DCP 3, CP A
7h DCP 3, CP B
8h DCP 4, CP A
9h DCP 4, CP B
Ah DCP 5, CP A
Bh DCP 5, CP B
Ch DCP 6, CP A
Dh DCP 6, CP B
Eh DCP 7, CP A
Fh DCP 7, CP B
NOTE: Reading CPOFF1 will clear the bit generating the current interrupt from appropriate flag
register BERINTFL, RLOSTFL, or BFINTFL except when in debug mode where reading
CPOFF1 will have no effect on the flag registers.
NOTE: In order to read INTTYPE1 and CPOFF1 simultaneously always read this register using
word or half-word but not using byte accesses.
1093
SPNU562–May 2014 High-End Timer Transfer Unit (HTU) Module
Submit Documentation Feedback
Copyright © 2014, Texas Instruments Incorporated