Datasheet

Instruction Set www.ti.com
23.5.3.12 ECNT (Event Count)
Syntax ECNT {
[brk={OFF | ON}]
[next={label | 9-bit unsigned integer}]
[reqnum={3-bit unsigned integer}
[request={NOREQ | GENREQ | QUIET}]
[control={OFF | ON}]
[prv={OFF | ON}]
[cond_addr={label | 9-bit unsigned integer}]
pin={pin number}
event={NAF | FALL | RISE | BOTH | ACCUHIGH | ACCULOW}
[reg={A | B | R| S | T | NONE}]
[irq={OFF | ON}]
[data={25-bit unsigned integer]
}
Figure 23-106. ECNT Program Field (P31:P0)
31 26 25 23 22 21 13 12 9 8 7 6 5 0
0 Request BRK Next program address 1010 Res. 01 Reserved
Number
6 3 1 9 4 1 2 6
Figure 23-107. ECNT Control Field (C31:C0)
31 29 28 27 26 25 24 22 21 16
Reserved Request type Control Prv. Reserved Conditional address
3 2 1 1 3 9
15 13 12 8 7 6 4 3 2 1 0
Conditional address Pin select Ext Event Res. Register select Int.
Reg ena
9 5 1 3 1 2 1
Figure 23-108. ECNT Data Field (D31:D0)
31 7 6 0
Data Reserved
25 7
Cycles One cycle
Register modified Selected Register (A, B, R, S, T or none)
Description This instruction defines a specialized 25-bit virtual counter used as an event
counter or pulse accumulator (see Table 23-61). The counter value is stored
in the data field [D31:D7] and the selected register. If one of the 32-bit
registers (R,S,T) is selected, the 25 bit count value is stored left justified in the
register with zeros in the seven least significant bits.
When an event count condition is specified, the counter value is incremented
on a pin edge condition or on the NAF condition (NAF is defined in ACNT).
This instruction can be used with all pins.
1030
High-End Timer (N2HET) Module SPNU562–May 2014
Submit Documentation Feedback
Copyright © 2014, Texas Instruments Incorporated