Datasheet

www.ti.com Instruction Set
23.5.3.9 DADM64 (Data Add Move)
Syntax DADM64 {
[brk={OFF | ON}]
[next={label | 9-bit unsigned integer}]
remote={label | 9-bit unsigned integer}
[request={NOREQ | GENREQ | QUIET}]
[control={OFF | ON}]
[en_pin_action={OFF | ON}]
[cond_addr={label | 9-bit unsigned integer}]
[pin={pin number}]
comp_mode={ECMP | SCMP | MCMP1 | MCMP2}
[action={CLEAR | SET | PULSELO | PULSEHI}]
[reg={A | B | R | S | T | NONE}]
[irq={OFF | ON}]
[data={25-bit unsigned integer]
[hr_data= {7-bit unsigned integer}]
}
-or-
Syntax DADM64 {
[brk={OFF | ON}]
[next={label | 9-bit unsigned integer}]
remote={label | 9-bit unsigned integer}
cntl_val={29-bit unsigned integer}
data={25-bit unsigned integer}
[hr_data= {7-bit unsigned integer}]
}
Figure 23-96. DADM64 Program Field (P31:P0)
31 26 25 23 22 21 13 12 9 8 0
0 Reserved BRK Next program address 0010 Remote Address
6 3 1 9 4 9
Figure 23-97. DADM64 Control Field (C31:C0)
31 29 28 27 26 25 23 22 21 16
Reserved Request type Control Reserved En. pin Conditional address
action
3 2 1 3 1 9
15 13 12 8 7 6 5 4 3 2 1 0
Conditional address Pin select Ext Comp. mode Action Register select Int.
Reg ena
9 5 1 2 2 2 1
1023
SPNU562–May 2014 High-End Timer (N2HET) Module
Submit Documentation Feedback
Copyright © 2014, Texas Instruments Incorporated