Datasheet

FlexRay Module Registers

www.ti.com

26.3.2.2.7 Interrupt Line Enable Register (ILE)

Each of the two interrupt lines (CC_int0, CC_int1) can be enabled / disabled separately by programming

bit EINT0 and EINT1.

Figure 26-123 and Table 26-108 illustrate this register.

Figure 26-123. Interrupt Line Enable Register (ILE) [offset_CC = 40h]

31 16

Reserved

R-0

15 2 1 0

Reserved EINT

R-0 R/W-0

LEGEND: R/W = Read/Write; R = Read only; -n = value after reset

Table 26-108. Interrupt Line Enable Register (ILE) Field Descriptions

Bit Field Value Description

31-2 Reserved 0 Read returns 0. Writes have no effect.

1-0 EINT Enable interrupt line (1-0).

0 Interrupt line CC_int1 and CC_int0 disabled

1h Interrupt line CC_int1 disabled and CC_int0 enabled

2h Interrupt line CC_int1 enabled and CC_int0 disabled

3h Interrupt line CC_int1 and CC_int0 enabled

1296

FlexRay Module SPNU563–May 2014

Submit Documentation Feedback