Datasheet

FlexRay Module Registers www.ti.com
Figure 26-76. Enable Transfer on Event to System Memory Set 2 (ETESMS2) [offset_TU = C8h]
31 16
ETESMS2(31-16)
R/S-0
15 0
ETESMS2(15-0)
R/S-0
LEGEND: R/W = Read/Write; R = Read only; C = Clear; S = Set; -n = value after reset
Table 26-62. Enable Transfer on Event to System Memory Set 2 Field Descriptions
Bit Field Value Description
31-0 ETESMS2(31-0) Enable Transfer on Event to System Memory Set 2. The register bits 0 to 31 correspond to
message buffers 32 to 63. Each bit of the register enables a message buffer transfer on event to
the system memory:
0 Transfer on event is disabled.
1 Transfer on event is enabled.
Figure 26-77. Enable Transfer on Event to System Memory Reset 2 (ETESMR2) [offset_TU = CCh]
31 16
ETESMR2(31-16)
R/C-0
15 0
ETESMR2(15-0)
R/C-0
LEGEND: R/W = Read/Write; R = Read only; C = Clear; S = Set; -n = value after reset
Table 26-63. Enable Transfer on Event to System Memory Reset 2 (ETESMR2) Field Descriptions
Bit Field Description
31-0 ETESMR2(31-0) Enable Transfer on Event to System Memory Reset 2. The ETESMR2 register shows the identical
values to ETESMS2 if read.
1250
FlexRay Module SPNU563–May 2014
Submit Documentation Feedback
Copyright © 2014, Texas Instruments Incorporated