Datasheet

FlexRay Module Registers

www.ti.com

Figure 26-57. Transfer Error Interrupt Enable Reset (TEIRER) [offset_TU = 7Ch]

31 16

Reserved

R-0

15 11 10 8 7 6 4 3 2 1 0

Reserved RSTAT RSVD WSTAT Reserved TNRE FACE

R-0 R/C-0 R-0 R/C-0 R-0 R/C-0 R/C-0

LEGEND: R/W = Read/Write; R = Read only; C = Clear; S = Set; -n = value after reset

Table 26-43. Transfer Error Interrupt Enable Reset (TEIRER)

Bit Field Value Description

31-11 Reserved 0 Reads return 0. Writes have no effect.

10-8 RSTATE Read Error Interrupt Generation (interrupt generation on VBUS read transfer errors).

0 Interrupt generation on VBUS read transfer error disabled.

7h Interrupt generation on VBUS read transfer error enabled.

Note: Any value different from 111 does not guarantee the interrupt error generation of all possible

VBUS read errors.

7 Reserved 0 Reads return 0. Writes have no effect.

6-4 WSTATE Write Error Interrupt Generation (interrupt generation on VBUS write transfer errors).

0 Interrupt generation on VBUS write transfer error disabled.

7h Interrupt generation on VBUS write transfer error enabled.

Note: Any value different from 111 does not guarantee the interrupt error generation of all possible

VBUS read errors.

3-2 Reserved 0 Reads return 0. Writes have no effect.

1 TNRE Transfer Not Ready Enable.

0 TNR interrupt disabled.

1 TNR interrupt enabled.

0 FACE Forbidden Access Enable.

0 FAC interrupt disabled.

1 FAC interrupt enabled.

1240

FlexRay Module SPNU563–May 2014

Submit Documentation Feedback