Datasheet

M51
M50
M47
Bit 0 Bit(n-1) (n-2) (n-3) (n-4)
Bit 0 Bit(n-1) (n-2) (n-3) (n-4)
CLKX
FSX
DX
DR
M44
M48
M49
M43
LSB
MSB
M52
145
TMS320F28379S , TMS320F28377S
TMS320F28376S, TMS320F28375S, TMS320F28374S
www.ti.com SPRS881C –AUGUST 2014–REVISED MAY 2016
Submit Documentation Feedback
Product Folder Links: TMS320F28379S TMS320F28377S TMS320F28376S TMS320F28375S TMS320F28374S
SpecificationsCopyright © 2014–2016, Texas Instruments Incorporated
For CLKSTP = 10b and CLKXP = 1, Table 5-75 shows the timing requirements, Table 5-76 shows the
switching characteristics, and Figure 5-64 shows the timing diagram.
(1) For all SPI slave modes, CLKX has to be a minimum of 8 CLKG cycles. Furthermore, CLKG should be LSPCLK/2 by setting CLKSM =
CLKGDV = 1.
(2) 2P = 1/CLKG
Table 5-75. McBSP as SPI Master or Slave Timing Requirements (CLKSTP = 10b, CLKXP = 1)
(1)
NO.
MASTER SLAVE
UNIT
MIN MAX MIN MAX
M49 t
su(DRV-CKXH)
Setup time, DR valid before CLKX high 30 8P – 10 ns
M50 t
h(CKXH-DRV)
Hold time, DR valid after CLKX high 1 8P – 10 ns
M51 t
su(FXL-CKXL)
Setup time, FSX low before CLKX low 8P + 10 ns
M52 t
c(CKX)
Cycle time, CLKX 2P
(2)
16P ns
(1) 2P = 1/CLKG
Table 5-76. McBSP as SPI Master or Slave Switching Characteristics Over Recommended Operating
Conditions (Unless Otherwise Noted) (CLKSTP = 10b, CLKXP = 1)
NO. PARAMETER
MASTER SLAVE
UNIT
MIN MAX MIN MAX
M43 t
h(CKXH-FXL)
Hold time, FSX low after CLKX high 2P
(1)
ns
M44 t
d(FXL-CKXL)
Delay time, FSX low to CLKX low P ns
M47 t
dis(FXH-DXHZ)
Disable time, DX high impedance following last data bit from
FSX high
6 6P + 6 ns
M48 t
d(FXL-DXV)
Delay time, FSX low to DX valid 6 4P + 6 ns
Figure 5-64. McBSP Timing as SPI Master or Slave: CLKSTP = 10b, CLKXP = 1