Datasheet

14
CC2650
SWRS158B –FEBRUARY 2015–REVISED JULY 2016 www.ti.com
Submit Documentation Feedback
Product Folder Links: CC2650
Specifications Copyright © 2015–2016, Texas Instruments Incorporated
(1) Single-ended RF mode is optimized for size and power consumption. Measured on CC2650EM-4XS.
(2) Differential RF mode is optimized for RF performance. Measured on CC2650EM-5XD.
(3) I
peri
is not supported in Standby or Shutdown.
5.4 Power Consumption Summary
Measured on the TI CC2650EM-5XD reference design with T
c
= 25°C, V
DDS
= 3.0 V with internal DC-DC converter, unless
otherwise noted.
PARAMETER TEST CONDITIONS MIN TYP MAX UNIT
I
core
Core current consumption
Reset. RESET_N pin asserted or VDDS below
Power-on-Reset threshold
100
nA
Shutdown. No clocks running, no retention 150
Standby. With RTC, CPU, RAM and (partial)
register retention. RCOSC_LF
1
µA
Standby. With RTC, CPU, RAM and (partial)
register retention. XOSC_LF
1.2
Standby. With Cache, RTC, CPU, RAM and
(partial) register retention. RCOSC_LF
2.5
Standby. With Cache, RTC, CPU, RAM and
(partial) register retention. XOSC_LF
2.7
Idle. Supply Systems and RAM powered. 550
Active. Core running CoreMark
1.45 mA +
31 µA/MHz
Radio RX
(1)
5.9
mA
Radio RX
(2)
6.1
Radio TX, 0-dBm output power
(1)
6.1
Radio TX, 5-dBm output power
(2)
9.1
Peripheral Current Consumption (Adds to core current I
core
for each peripheral unit activated)
(3)
I
peri
Peripheral power domain Delta current with domain enabled 20 µA
Serial power domain Delta current with domain enabled 13 µA
RF Core
Delta current with power domain enabled, clock
enabled, RF core idle
237 µA
µDMA Delta current with clock enabled, module idle 130 µA
Timers Delta current with clock enabled, module idle 113 µA
I
2
C Delta current with clock enabled, module idle 12 µA
I2S Delta current with clock enabled, module idle 36 µA
SSI Delta current with clock enabled, module idle 93 µA
UART Delta current with clock enabled, module idle 164 µA
(1) This number is dependent on Flash aging and will increase over time and erase cycles.
5.5 General Characteristics
Measured on the TI CC2650EM-5XD reference design with T
c
= 25°C, V
DDS
= 3.0 V, unless otherwise noted.
PARAMETER TEST CONDITIONS MIN TYP MAX UNIT
FLASH MEMORY
Supported flash erase cycles before
failure
100 k Cycles
Flash page/sector erase current Average delta current 12.6 mA
Flash page/sector size 4 KB
Flash write current Average delta current, 4 bytes at a time 8.15 mA
Flash page/sector erase time
(1)
8 ms
Flash write time
(1)
4 bytes at a time 8 µs