Datasheet

35
CC1310
www.ti.com SWRS181C –SEPTEMBER 2015–REVISED OCTOBER 2016
Submit Documentation Feedback
Product Folder Links: CC1310
Detailed DescriptionCopyright © 2015–2016, Texas Instruments Incorporated
(1) Depending on the package size, up to 15 pins can be connected to the Sensor Controller. Up to eight
of these pins can be connected to analog modules.
Table 6-1. GPIOs Connected to the Sensor Controller
(1)
ANALOG CAPABLE
CC13x0
7 × 7 RGZ
DIO NUMBER
5 × 5 RHB
DIO NUMBER
4 × 4 RSM
DIO NUMBER
Y 30 14
Y 29 13
Y 28 12
Y 27 11 9
Y 26 9 8
Y 25 10 7
Y 24 8 6
Y 23 7 5
N 7 4 2
N 6 3 1
N 5 2 0
N 4 1
N 3 0
N 2
N 1
N 0
6.5 Memory
The flash memory provides nonvolatile storage for code and data. The flash memory is in-system
programmable.
The SRAM (static RAM) is split into two 4-KB blocks and two 6-KB blocks and can be used to store data
and execute code. Retention of the RAM contents in standby mode can be enabled or disabled
individually for each block to minimize power consumption. In addition, if flash cache is disabled, the 8-KB
cache can be used as general-purpose RAM.
The ROM provides preprogrammed, embedded TI-RTOS kernel and Driverlib. The ROM also contains a
bootloader that can be used to reprogram the device using SPI or UART.
6.6 Debug
The on-chip debug support is done through a dedicated cJTAG (IEEE 1149.7) or JTAG (IEEE 1149.1)
interface.