Datasheet

Jumpers

Output

Load

Capacitors

Input

Load

Resistors

Introduction

www.ti.com

Figure 3. The EVM Top Photograph

The 4-pin jumpers on top of the EVM provide for an input or output pin to be tied to either Vcc or ground.

The jumper also provides scope probe access to each pin.

Figure 4. The EVM Bottom Photograph

Each channel is configured with a 50-Ω load resistor on each input, labeled R1 through R4, and a 4.7-pF

load on each channel output labeled C1 through C4. Note that each channel may be configured for

operation in either direction by simply switching the input load resistor with the output load capacitor.

Triple- and Quad-Channel Digital Isolator EVM SLAU253A– June 2008– Revised September 2011

Submit Documentation Feedback