Datasheet

ISO15, ISO35
ISO15M, ISO35M
SLOS580F – MAY 2008– REVISED JANUARY 2012 www.ti.com
REVISION HISTORY
Changes from Original (May 2008) to Revision A Page
• Changed L(101) Minimum air gap (Clearance) From 7.7mm To 8.34mm. ........................................................................ 10
• Deleted CSA information from the Regulatory Information Table. ..................................................................................... 10
• Changed From 40014131 To 40016131 ............................................................................................................................. 10
Changes from Revision A (June 2008) to Revision B Page
• Changed From: 4000-Vpeak Isolation To: 4000-Vpeak Isolation, 560-Vpeak VIORM UL 1577, IEC 60747-5-2 (VDE
0884, Rev 2) ......................................................................................................................................................................... 1
• Changed Figure 13, Full-Duplex Common-Mode Transient Immunity Test Circuit .............................................................. 8
Changes from Revision B (July 2008) to Revision C Page
• Added added IEC......Approved ............................................................................................................................................ 1
• Added added CSA information column back in table ......................................................................................................... 10
Changes from Revision C (December 2008) to Revision D Page
• Changed Propagation delay values From: μs To: ns in the DRIVER SWITCHING table .................................................... 3
Changes from Revision D (March 2009) to Revision E Page
• Added devices ISO15M and ISO35M to the data sheet ....................................................................................................... 1
• Changed Description - From: The ISO15 and ISO35 are qualified for use from –40°C to 85°C. To: The ISO15M and
ISO35M have extended ambient temperature ratings of –55°C to 125°C while the ISO15 and ISO35 are specified
over –40°C to 85°C. .............................................................................................................................................................. 1
• Added the Product Information table .................................................................................................................................... 1
• Added Added Ambient Temp information in the RECOMMENDED OPERATING CONDITIONS table .............................. 2
• Added ISO15M and ISO35M to the Operating junction temperature in the RECOMMENDED OPERATING
CONDITIONS table ............................................................................................................................................................... 2
• Changed the DRIVER ELECTRICAL table, I
OZ
High-impedance state output current - Test Condition V
Y
or V
Z
= 12
V, V
CC
= 0 values From: TYP = -10 , MAX = - To: TYP = -, MAX = 90. .............................................................................. 3
• Changed the DRIVER ELECTRICAL table, I
OZ
High-impedance state output current - Test Condition V
Y
or V
Z
= –7
V values From: TYP = -, MAX = 90 To: TYP = -10, MAX = - ............................................................................................... 3
• Added t
r
, t
f
limits for the ISO15M ans ISO35M devices ........................................................................................................ 3
• Added I
A
or I
B
limits for the ISO15M ans ISO35M devices ................................................................................................... 4
• Added pulse skew limits for the ISO15M ans ISO35M devices ........................................................................................... 4
• Added t
r
, t
f
for the ISO15M ans ISO35M devices ................................................................................................................. 4
• Added the Driver output pins Note for Figure 1 through Figure 4 ........................................................................................ 5
• Changed the Driver output pins Note for eFigure 5 through Figure 6 .................................................................................. 6
• Added Note 1 to Table 1 Driver Function Table ................................................................................................................... 9
• Added Note 1 to Table 2 Receiver Function Table .............................................................................................................. 9
• Changed Figure 19 - replaced curves ................................................................................................................................ 14
• Changed Figure 20 - replaced curves ................................................................................................................................ 14
16 Submit Documentation Feedback Copyright © 2008–2012, Texas Instruments Incorporated
Product Folder Link(s): ISO15 ISO35 ISO15M ISO35M