Datasheet

Recommended Equipment

www.ti.com

Table 2. EVM Configuration Options for ISO35T and ISO3086T (continued)

Jumper Function Configuration I/O Load

JMP8 – Y Output R10 set source termination across R10 – 54 Ω

JMP9 – Z Output mmm Driver pins Y and Z R10 – 54 Ω

JMP25 – A Test Point

JMP26 – Z Test Point

JMP27 – B Test Point

JMP28 – Y Test Point

JMP29 – GND2 Jumper installed from pin 1 to pin 2 Jumper short installed to short U1-10 to

GND2

JMP32 – Regulator Output Connects regulator output to Vcc2. Remove

this jumper when connecting power

externally (regulator not In use)

2.2 Bill of Materials

The items used in the ISO1176T/35T/3086TEVM are listed in the bill of materials in Table 3, Table 4, and

Table 5.

Table 3. ISO1176TEVM Bill of Material

Item Qty Reference Value Footprint Manufacturer Part Number

1 1 C2 68 µF cc7260 SPRAGUE 592D68X0010R2T

2 1 C3 10 µF cc7343 SPRAGUE 293D106X0035D2W

3 1 C4 1 µF cc1206 AVX 12063G105ZATRA

4 1 C5 0.1 µF cc1206 AVX 12065C104JATMA

5 1 C6 0.01 µF cc0805 AVX 06033G102JATMA

6 1 C7 DNI cc0805

7 2 C15, C17 10 µF cc1206

8 1 C16 22 µF cc1210

9 2 D1,D2 1N5817

10 10 JMP1, JMP16, JMP22–JMP29 Header 3x1

11 8 JMP2–JMP9 Header 4x1

12 3 JMP30–JMP32 Header 2x1

13 2 P1, P2 Banana-Jack bjack ITT-POMONA 3267

14 1 R1 1K r0805

15 5 R2, R3, R4 49.9 r0805

16 2 R7, R8, R10, R11 DNI r0805

17 1 R9 54 r0805

18 1 T1 DA2304-AL Coil Craft DA2304-AL

19 1 U1 ISO1176T 16 pin DW TI ISO1176T

20 1 U3 LP2985A- SOT23-5 TI LP2985A-50DBVR

50DBVR

ISO1176T/35T/3086T Evaluation Module SLLU122A–April 2010–Revised July 2010