Datasheet
ISO1176
SLLS897D –MARCH 2008–REVISED MARCH 2010
www.ti.com
These devices have limited built-in ESD protection. The leads should be shorted together or the device placed in conductive foam
during storage or handling to prevent electrostatic damage to the MOS gates.
ABSOLUTE MAXIMUM RATINGS
over operating junction temperature range unless otherwise noted
(1)
VALUE UNIT
V
CC1
,
Supply voltage
(2)
–0.5 to 7 V
V
CC2
V
O
Voltage at any bus I/O terminal –9 to 14 V
V
I
Voltage input at any D, DE or RE terminal –0.5 to 7 V
I
O
Receiver output current ±10 mA
Bus pins to GND1 ±6
Human Body
JEDEC Standard 22, Test Method A114-C.01 Bus pins to GND2 ±16
Model
kV
Electrostatic All pins ±4
ESD
discharge
Charged Device
JEDEC Standard 22, Test Method C101 All pins ±1
Model
Machine model ANSI/ESDS5.2-1996 All pins ±200 V
T
J
Maximum junction temperature 170 °C
(1) Stresses beyond those listed under absolute maximum ratings may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under recommended operating
conditions is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability. All voltage
values are with respect to the network ground terminal unless otherwise noted.
(2) All voltage values except differential I/O bus voltages are with respect to the referenced network ground terminal and are peak voltage
values.
RECOMMENDED OPERATING CONDITIONS
MIN TYP MAX UNIT
Logic side supply voltage, V
CC1
(with respect to GND1) 3.15 5.5
V
CC
V
Bus side supply voltage, V
CC2
(with respect to GND2) 4.75 5.25
V
CM
Voltage at either bus I/O terminal A, B –7 12 V
PV, RE 2 V
CC1
V
IH
High-level input voltage V
D, DE 0.7 V
CC1
PV, RE 0 0.8
V
IL
Low-level input voltage V
D, DE 0.3 V
CC1
V
ID
Differential input voltage A with respect to B –12 12 V
Driver –70 70
I
O
Output current mA
Receiver –8 8
Input pulse width 10 ns
T
J
Operating junction temperature –40 150 °C
SUPPLY CURRENT
over recommended operating conditions (unless otherwise noted)
PARAMETER TEST CONDITIONS MIN TYP MAX UNIT
DE at 0 V 4 6
3 V DE at V
CC1
, 2 Mbps 5 mA
DE at V
CC1
, 25 Mbps 6
I
CC1
Logic side RMS supply current
DE at 0 V 7 10
5.5 V DE at V
CC1
, 2 Mbps 8 mA
DE at V
CC1
, 25 Mbps 11
2 Submit Documentation Feedback Copyright © 2008–2010, Texas Instruments Incorporated
Product Folder Link(s) :ISO1176