Datasheet

www.ti.com System Setup
Figure 4 illustrates the system setup for the INA219_Test_Board schematic. D1 is an LED that indicates
whether the INA219 Test Board is receiving power. Jumpers allow the selection of the power source as
well as configuration of A0 and A1. Connector T4 allows the connection of the shunt and bus voltages.
Figure 4. INA219_Test_Board Schematic
5
SBOU074A–January 2009–Revised February 2010 INA219 Evaluation Module
Submit Documentation Feedback
Copyright © 2009–2010, Texas Instruments Incorporated