Datasheet

INA210 , INA211 , INA212 , INA213 , INA214 , INA215
www.ti.com SBOS437F –MAY 2008–REVISED JUNE 2014
Pin Functions
PIN
NO. I/O DESCRIPTION
NAME
DCK RSW
GND 2 9 Analog Ground
Analog
IN– 5 4, 5 Connect to load side of shunt resistor.
input
Analog
IN+ 4 2, 3 Connect to supply side of shunt resistor
input
NC — 1, 7 — Not internally connected. Leave floating or connect to ground.
Analog
OUT 6 10 Output voltage
output
Analog
REF 1 8 Reference voltage, 0 V to V+
input
V+ 3 6 Analog Power supply, 2.7 V to 26 V
7 Specifications
7.1 Absolute Maximum Ratings
(1)
over operating free-air temperature range (unless otherwise noted)
MIN MAX UNIT
Supply voltage, V
S
26 V
Differential (V
IN+
) – (V
IN–
) –26 26 V
Analog inputs, V
IN+
, V
IN–
(2)
Common-mode
(3)
GND – 0.3 26 V
REF input GND – 0.3 (V
S
) + 0.3 V
Output
(3)
GND – 0.3 (V
S
) + 0.3 V
Input current into any terminal
(3)
5 mA
Operating temperature –55 150 °C
Junction temperature 150 °C
(1) Stresses beyond those listed under Absolute Maximum Ratings may cause permanent damage to the device. These are stress ratings
only, which do not imply functional operation of the device at these or any other conditions beyond those indicated under Recommended
Operating Conditions. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) V
IN+
and V
IN–
are the voltages at the IN+ and IN– terminals, respectively.
(3) Input voltage at any terminal may exceed the voltage shown if the current at that terminal is limited to 5 mA.
7.2 Handling Ratings
MIN MAX UNIT
T
stg
Storage temperature range –65 150 °C
Human body model (HBM) ESD stress voltage
(1)
–4000 4000
Electrostatic discharge
V
(ESD)
Charged-device model (CDM) ESD stress voltage
(2)
–1000 1000 V
(version A)
Machine model (MM) ESD stress voltage –200 200
Human body model (HBM) ESD stress voltage
(1)
–1500 1500
Electrostatic discharge
V
(ESD)
Charged-device model (CDM) ESD stress voltage
(2)
–1000 1000 V
(version B)
Machine model (MM) ESD stress voltage –100 100
(1) JEDEC document JEP155 states that 500-V HBM allows safe manufacturing with a standard ESD control process.
(2) JEDEC document JEP157 states that 250-V CDM allows safe manufacturing with a standard ESD control process.
Copyright © 2008–2014, Texas Instruments Incorporated Submit Documentation Feedback 5
Product Folder Links: INA210 INA211 INA212 INA213 INA214 INA215