Datasheet
Table Of Contents
- INA209 Evaluation Module
- Revision History
- Important Notices
System Setup
www.ti.com
Figure 4 illustrates the system setup for the INA209 test board schematic. LEDs D1 through D6 are used
as indicators for many of the digital signals (for example, Warning, Critical, GPIO, etc). Jumpers JMP1
through JMP8 allow the configuration of A0 and A1. Connector T1 allows the connection of shunt and bus
voltages.
Figure 4. INA209 Test Board Schematic
6
INA209 Evaluation Module SBOU055A–February 2008–Revised February 2010
Submit Documentation Feedback
Copyright © 2008–2010, Texas Instruments Incorporated