Datasheet

Table Of Contents

INA209EVM Hardware Setup

www.ti.com

3.6 INA209 Jumper Settings

Figure 10 shows the default jumper configuration for the INA209EVM. In general, the jumper settings of

the USB Dig platform do not need to be changed. However, you may want to change some of the jumpers

on the INA209 test board to match your specific device configuration (for example, to change the I

address).

Figure 10. Default Jumper Settings

Table 3 explains the function of the jumpers on the INA209 test board.

Table 3. INA209 Test Board Jumper Function

Jumper Default Purpose

A0 address select input. These jumpers determine where the

JMP1–JMP4 JMP1 address select pin is connected. This setting connects A0 to

GND.

A1 address select input. These jumpers determine where the

JMP5–JMP8 JMP5 address select pin is connected. This setting connects A1 to

GND.

This jumper determines where the INA209 gets its power supply.

JMP9 V

DUT

In the V

DUT

position, the EVM provides power. In the Vs_Ext

position, the power is connected externally.

INA209 Evaluation Module SBOU055A–February 2008–Revised February 2010

Submit Documentation Feedback