Datasheet

Table Of Contents

www.ti.com

INA209EVM Hardware Setup

3.5 Connecting the USB Cable to the INA209EVM

Figure 9 shows the typical response to connecting the USB Dig platform to a PC USB port for the first

time. Note that the EVM must be powered prior to connecting the USB cable. Typically, the computer will

respond with a Found New Hardware, USB Device pop-up. The pop-up typically changes to Found New

Hardware, USB Human Interface Device. This pop-up indicates that the device is ready to be used. The

USB Dig platform uses the Human Interface Device Drivers that are part of the Microsoft Windows

operating system.

In some cases, the Windows Add Hardware Wizard will pop-up. If this prompt occurs, allow the system

device manager to install the Human Interface Drivers by clicking Yes when requested to install drivers.

Figure 9. Connecting the USB Cable

SBOU055A–February 2008–Revised February 2010 INA209 Evaluation Module

Submit Documentation Feedback