Datasheet

INA199A1, INA199B1
INA199A2, INA199B2
INA199A3, INA199B3
SBOS469D –MAY 2009–REVISED NOVEMBER 2012 www.ti.com
This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling and installation procedures can cause damage.
ESD damage can range from subtle performance degradation to complete device failure. Precision integrated circuits may be more
susceptible to damage because very small parametric changes could cause the device not to meet its published specifications.
PACKAGE INFORMATION
(1)
PACKAGE
PRODUCT GAIN PACKAGE-LEAD DESIGNATOR PACKAGE MARKING
SC70-6 DCK OBG
INA199A1 50V/V
Thin QFN-10 RSW NSJ
SC70-6 DCK SEB
INA199B1 50V/V
Thin QFN-10 RSW SHV
SC70-6 DCK OBH
INA199A2 100V/V
Thin QFN-10 RSW NTJ
SC70-6 DCK SEG
INA199B2 100V/V
Thin QFN-10 RSW SHW
SC70-6 DCK OBI
INA199A3 200V/V
Thin QFN-10 RSW NUJ
SC70-6 DCK SHE
INA199B3 200V/V
Thin QFN-10 RSW SHX
(1) For the most current package and ordering information see the Package Option Addendum at the end of this document, or see the TI
web site at www.ti.com.
ABSOLUTE MAXIMUM RATINGS
(1)
Over operating free-air temperature range, unless otherwise noted.
VALUE UNIT
Supply Voltage +26 V
Differential (V
IN+
) – (V
IN–
) –26 to +26 V
Analog Inputs,
V
IN+
, V
IN–
(2)
Common-mode
(3)
GND – 0.3 to +26 V
REF Input GND – 0.3 to (V+) + 0.3 V
Output
(3)
GND – 0.3 to (V+) + 0.3 V
Input Current Into All Pins
(3)
5 mA
Operating Temperature –40 to +125 °C
Storage Temperature –65 to +150 °C
Junction Temperature +150 °C
Human Body Model (HBM) 4000 V
ESD Ratings:
Charged-Device Model (CDM) 1000 V
(version A)
Machine Model (MM) 200 V
Human Body Model (HBM) 1500 V
ESD Ratings:
Charged-Device Model (CDM) 1000 V
(version B)
Machine Model (MM) 100 V
(1) Stresses above these ratings may cause permanent damage. Exposure to absolute maximum conditions for extended periods may
degrade device reliability. These are stress ratings only, and functional operation of the device at these or any other conditions beyond
those specified is not implied.
(2) V
IN+
and V
IN–
are the voltages at the IN+ and IN– pins, respectively.
(3) Input voltage at any pin may exceed the voltage shown if the current at that pin is limited to 5mA.
2 Submit Documentation Feedback Copyright © 2009–2012, Texas Instruments Incorporated
Product Folder Links: INA199A1 INA199B1 INA199A2 INA199B2 INA199A3 INA199B3