Datasheet

INA152
2
SBOS184
SPECIFICATIONS: V
S
= ±10V
INA152EA
PARAMETER CONDITIONS MIN TYP MAX UNITS
OFFSET VOLTAGE RTO
(1) (2)
Input Offset Voltage V
CM
= 0V ±250 ±1500 µV
vs Temperature T
A
= –40°C to +85°C ±3 ±15 µV/°C
vs Power Supply V
S
= ±1.35V to ±10V 5 30 µV/V
vs Time 0.5 µV/mo
INPUT VOLTAGE RANGE
(3)
Common-Mode Voltage Range
V
IN+
– V
IN–
= 0V 2(V–) 2(V+) – 2V
Common-Mode Rejection 80 94 dB
INPUT IMPEDANCE
(4)
Differential 80 kΩ
Common-Mode 80 kΩ
OUTPUT NOISE VOLTAGE
(1) (5)
RTO
f
O
= 10Hz 97 nV/√Hz
f
O
= 1kHz 87 nV/√Hz
f
B
= 0.1Hz to 10Hz 2.4 µVp-p
GAIN
Initial
(6)
1 V/V
Gain Error ±0.01 ±0.1 %
Gain Temperature Drift Coefficient ±1 ±10 ppm/°C
Nonlinearity (V–) + 0.3V < V
O
< (V+) – 0.350V ±0.002 ±0.005 % of FS
FREQUENCY RESPONSE
Small Signal 800 kHz
Slew Rate 0.4 V/µs
Settling Time, 0.1% 9V Step 23 µs
, 0.01% 9V Step 25 µs
Overload Recovery 50% Overdrive 5 µs
OUTPUT
Voltage R
L
= 10kΩ to GND (V+) – 0.35 (V+) – 0.02 V
(V–) + 0.3 (V–) + 0.15 V
Load Capacitance Stability 500 pF
Short-Circuit Curent Continuous to Common +7, –12 mA
POWER SUPPLY
Rated Voltage ±10 V
Voltage Range ±1.35 ±10 V
2.7 20 V
Current, Quiescent I
O
= 0mA 500 650 µA
TEMPERATURE RANGE
Specification –40 +85 °C
Operating –55 +125 °C
θ
JA
, Junction to Ambient 150 °C/W
T
A
= +25°C, V
S
= ±10V, R
L
= 10kΩ connected to ground, and reference pin connected to ground, unless otherwise noted.
NOTES: (1) Referred to output in unity-gain difference configuration. Note that this circuit has a gain of 2 for the op amp’s offset voltage and noise voltage.
(2) Includes effects of amplifier’s input bias and offset currents. (3) Limit I
IN
through 40kΩ resistors to 1mA. (4) 40kΩ resistors are ratio matched but have ±20%
absolute value. (5) Includes effects of amplifier’s input current noise and thermal noise contribution of resistor network. (6) Connected as difference amplifier.