Datasheet

INA106
2
SBOS152A
www.ti.com
INA106KP, U
PARAMETER CONDITIONS MIN TYP MAX UNITS
GAIN
Initial
(1)
10 V/V
Error 0.01 0.025 %
vs Temperature –4 ppm/°C
Nonlinearity
(2)
0.0002 0.001 %
OUTPUT
Related Voltage I
O
= +20mA, –5mA 10 12 V
Rated Current V
O
= 10V +20, –5mA
Impedance 0.01 Ω
Current Limit To Common +40/–10 mA
Capacitive Load Stable Operation 1000 pF
INPUT
Impedance Differential 10 kΩ
Common-Mode 110 kΩ
Voltage Range Differential ±1V
Common-Mode ±11 V
Common-Mode Rejection
(3)
T
A
= T
MIN
to T
MAX
86 100 dB
OFFSET VOLTAGE RTI
(4)
Initial 50 200 µV
vs Temperature 0.2 µV/°C
vs Supply ±V
S
= 6V to 18V 1 10 µV/V
vs Time 10 µV/mo
NOISE VOLTAGE RTI
(5)
f
B
= 0.01Hz to 10Hz 1 µVp-p
f
O
= 10kHz 30 nV/√Hz
DYNAMIC RESPONSE
Small Signal –3dB 5 MHz
Full Power BW V
O
= 20Vp-p 30 50 kHz
Slew Rate 23 V/µs
Settling Time: 0.1% V
O
= 10V Step 5 µs
0.01% V
O
= 10V Step 10 µs
0.01% V
CM
= 10V Step, V
DIFF
= 0V 5 µs
POWER SUPPLY
Rated ±15 V
Voltage Range Derated Performance ±5 ±18 V
Quiescent Current V
O
= 0V ±1.5 ±2mA
TEMPERATURE RANGE
Specification 0 +70 °C
Operation –40 +85 °C
Storage –65 +150 °C
SPECIFICATIONS
ELECTRICAL
At +25°C, V
S
= ±15V, unless otherwise specified.
NOTES: (1) Connected as difference amplifier (see Figure 1). (2) Nonlinearity is the maximum peak deviation from the best-fit straight line as a percent of full-scale peak-
to-peak output. (3) With zero source impedance (see “Maintaining CMR” section). (4) Includes effects of amplifiers’s input bias and offset currents. (5) Includes effect
of amplifier’s input current noise and thermal noise contribution of resistor network.