User Manual

September 2001 S6350 Reader Reference Guide

2.1.6 Baseband receiver

Minimum data pulse width 5uS

Maximum data pulse width 500uS

Typical settling time 50uS from the first transition

Note:

The receiver extracts the mean level of the incoming data stream as

a reference. This takes approximately 50uS; therefore the data

output of the receiver is not valid until after this time.

2.1.7 Connector Details

All reader input and output is provided through a 16-pin header connector that is mounted on the

backside of the reader for the RI-STU-TRDC-02 and on the component side for the RI-STU-

TRDC-01. The details and orientation of each connector pin are provided in the following tables.

2.1.8 16-pin Header Connector CN1

Pin Function

1 0 Volts

2 +5 Volts

3 Open collector output / data input 2

4 Open collector output / data input 1

5 RS232 TxD (output from reader)

6 RS232 RxD (input to reader)

7 No connection (antenna guard)

8 Antenna screen

9 Antenna signal

10 No connection (antenna guard)

11 RS232 ground

12 No connection (reserved for future expansion)

13 No connection (reserved for future expansion)

14 No connection (reserved for future expansion)

15 No connection (reserved for future expansion)

16 No connection (reserved for future expansion)

CAUTION:

Only pins 8 and 9 of connector CN1 should be used for

the antenna connection.