User's Manual
Table Of Contents
- Table of Contents
- 1 Gas Sensor Platform Reference Design User's Guide
- 2 Features
- 3 Hardware Description
- 4 Antenna Simulations
- 5 Schematics and Bill Of Materials
- 6 Layout
- 7 Practical Applications
- A SAT0009 Power Board Files
- Important Notices
- Important Notices
www.ti.com
Firmware Section
7.2 Firmware Section
One of the development platforms for the CC2451 8051 microcontroller is the IAR development platform.
See http://www.iar.com/ for information on this platform.
To communicate to the development platform through IAR, the CC Debugger is required. See Section 3.1.
The CC Debugger must be connected to the 10-pin header on the SAT0010 board. Make sure that the
notch on the cable that connects to the 10-pin header is facing away from the sensor or toward the
outside. If connected properly, the LED on the CC Debugger should turn green.
Figure 7-6. CC Debugger
Figure 7-7. Launching IAR
Launch the project file as shown in Figure 7-7.
37
SNOA922–April 2013 Practical Applications
Submit Documentation Feedback
Copyright © 2013, Texas Instruments Incorporated